Collection: Orton Vent Master®

Developed by Orton Ceramic Foundation the Vent Master® works by creating a small downdraft within the kiln, the chamber is kept at a slight negative pressure. Gases and Fumes are pulled out of the kiln through a small hole and mixed with fresh room air then exhausted to the outside atmosphere through a 100mm duct (this length of duct is supplied by customer). 

The system gives the following benefits:

• Fume removal improves firings

• Extends life of elements by removing moisture

• Can aid in cooling of the kiln if desired

• Improves temperature uniformity in the chamber

• Helps to remove poisonous & corrosive fumes

• The unit can usually sit within the footprint of the kiln

Expansion Kits are also available to enable two kilns to run off a single Vent Master motor.

Watch Vent Master installation tutorial here. 

See Vent Master FAQ's here.

Manufacturers Warranty applies - please refer to their website: https://www.ortonceramic.com